Accu slide manual

 · About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy Safety How YouTube works Test new features Press Copyright Contact us Creators. II. Fully Assembled Picture Frame Installation BAL Accu-Slide™ System PLACING ACCU-SLIDE MECHANICS • IF YOU HAVE TOP-MOUNTED MECHANICS 1. Inside of room should now look like Figure 1. 2. Cut the tie straps that are holding the . The Accu-Slide is a give and take system between the cables, if the inside and outside opposing cables are too tight you will cause the motor to be over worked leading to trouble later on. When the room is seated full out, the OUTSIDE cables should be slack enough to move the cable approximately ½” up or down (1” total movement) by hand.

In the manual, the cable adjustment section starts on Page 6. A sticker placed near the slide has information on how to adjust the system. Each cable chain connector is color-coded for easy identification. Be sure to read over the entire section on adjusting cables, as well as the sticker directions, before you start doing anything. Accu-Slice ® Manual A Band Saw Wood Slicing Accessory Patent Pending Scientific Instrument Services Old York Rd Ringoes, NJ Phone: BAL Accu-Slide™ System II. Getting Started 7 Service Manual Prin ted in the U.S.A. If an ACCU-Slide system is not making the proper seal when it is either open or closed, it needs to be re-adjusted. The best way to perform an. The example diagram below is showing the association between cable adjusters and cables. Red Blue Green Purple 6.

At just a fraction of the cost of a slide scanner, ACCU-SlideMS Manual Slide Scanning System uses your existing microscope. Our intuitive ACCU-Slide software and the high-speed , MP camera enable users to scan as little or as much of an entire slide as is needed, resulting in high resolution images for documentation, analysis and more!. The Accu-Slide is a give and take system between the cables, if the inside and outside opposing cables are too tight you will cause the motor to be over worked leading to trouble later on. When the room is seated full out, the OUTSIDE cables should be slack enough to move the cable approximately ½” up or down (1” total movement) by hand. We would like to show you a description here but the site won’t allow us.